Konect Fusion G2 3660 1800 KV IP67 Crawler 1/10 brushless combo - KN-3660-FUS1800-G2

The Konect Fusion G2 KN-3660-FUS1800-G2 is a brushless motor and controller package designed for 1/10 scale RC crawlers . This motor system uses a 3660 sensored 1800 KV brushless motor, paired with a control system designed for the slow and precise maneuvers characteristic of RC crawling. Its IP67 rating makes it suitable for outdoor use, while its electronics include a selectable voltage BEC to power the receiver and servos.

In a crawler or scale RC vehicle, the motor should prioritize vehicle control over top speed. The brushless motor converts battery power into rotation, while the electronic controller manages acceleration, braking, and power delivery. Sensored technology uses an integrated magnetic encoder to detect the rotor's position. The system also benefits from FOC (Front of Control), a technology dedicated to precise motor control, with linear operation at very low speeds and torque at low RPMs.

The Fusion G2 is designed for 2S to 3S LiPo batteries as well as 4 to 9 cell NiMH packs. This compatibility allows it to be integrated into an electrical system suitable for a 1/10 scale crawler. The switching BEC can be set to 6.0V, 7.4V, or 8.4V . It delivers 4A continuously and up to 8A maximum for powering the receiver and connected equipment, including a steering servo compatible with the selected BEC voltage.

The controller accepts a compatible LED programming card . This programming allows access to settings such as thermal protection, number of cells, low-voltage cutoff, BEC voltage, direction of rotation, neutral zone, low-speed power, braking power, and motor brake. Calibration with the transmitter allows the throttle travel to be adapted to the radio system being used.

The motor incorporates several protection features, including protection against overheating, overvoltage, overcurrent, low battery voltage, and signal loss. To preserve the equipment, it is essential to observe the correct battery polarity, check the wiring before powering on, and disconnect the battery after use. The motor should also be allowed to cool completely before any handling after riding.

The 3660-format motor measures 36 mm in diameter and 56 mm in length , with a 3.175 mm shaft. This information is useful for verifying the compatibility of the motor pinion and the available space within the chassis. With a claimed weight of 177.8 g , the Konect Fusion G2 is a brushless solution designed for converting, replacing, or equipping a compatible 1/10 scale crawler.

Technical specifications

• Brand: Konect
• Reference: KN-3660-FUS1800-G2
• Type: Brushless sensored motor and controller combo
• Use: 1/10 scale RC crawler
• Engine format: 3660
• Rated speed: 1800 KV
• Direct current: 40 A
• Power supply: 2S to 3S LiPo or 4 to 9 cell NiMH
• Adjustable switching BEC: 6.0 V / 7.4 V / 8.4 V
• BEC current: 4 A continuous, 8 A maximum
• Programming: Compatible LED programming board
• Motor dimensions: Ø36 × 56 mm
• Shaft diameter: Ø3.175 mm
• Weight: 177.8 g
• Protection: IP67